53
5.3.1.3 Wireless (Only available for 7300N)
Parameters
WLAN Service: Default setting is set to Enable.
Mode: The default setting is 802.11g+n (Mixed mode). If you do not know or have both
11g and 11n devices in your network, then keep the default in mixed mode. From the
drop-down manual, you can select 802.11g if you have only 11g card. If you have only 11b
card, then select 802.11b. If you have only 11n card, then select 802.11n.
ESSID: The ESSID is the unique name of a wireless access point (AP) to be
distinguished from another. For security propose, change to a unique ID name to the AP
which is already built-in to the router’s wireless interface. It is case sensitive and must not
excess 32 characters. Make sure your wireless clients have exactly the ESSID as the device,
in order to get connected to your network.
Note: ESSID is case sensitive and must not excess 32 characters.
Hide ESSID: It is function in which transmits its ESSID to the air so that when wireless
client searches for a network, router can then be discovered and recognized. Default setting
is Disable.
~ Enable: Select Enable if you do not want broadcast your ESSID. When select Enable,
To Next Page
Loading...
Need help?
General
