Billy Goat KV - Install the Throttle Cable; Install the Clutch Cable; Install the Debris Bag and Final Setup

11
Install the Throttle Cable
9
A
D
B
C
E
F
1. Attach the throttle lever (A, Figure 9) to outside the
handle tubing. Insert bolt (B) with washer (C) from the
inside, with the threads facing outward.
2. Secure the throttle lever with second washer (D) and nut
(E).
3. Tighten the throttle assembly with a 7/16” socket and
wrench.
4. Zip-tie (F) the cable to the handle to secure for operation.
Install the Clutch Cable
Self-Propelled Models Only
10
A
D
B
C
E
F
1. Route the clutch cable (A, Figure 10) on the handle, up to
the bail (B).
2. On the end of the clutch cable is a fitting. Install the fitting
into the hole on the bail (B).
3. Use bolt (C), with threads facing out, to fasten the plastic
cable connection on the inside of the handle. Secure the
plastic cable connection with washer (D) and acorn nut
(E).
4. Tighten the cable connection with 7/16” socket and
wrench.
5. Zip-tie (F) the cable to the handle to secure for operation.
Install the Debris Bag and Final Setup
11
1. Unfold the debris bag (A, Figure 11) and locate the quick
disconnect scoop (B).
2. Insert the quick disconnect scoop into the bag through
the back opening. Maneuver the quick disconnect scoop
through the bag and out the small opening (C) at the
bottom.
3. Secure the quick disconnect scoop to the debris bag with
theaction spring bucklestrap included. Be sure the strap
is tight to prevent debris from escaping during operation.
Close the debris bag.
4. Install the assembled debris bag onto the housing
discharge chute. Open the discharge flap (D) and slide
the quick disconnect scoop downward onto the housing
discharge chute.
5. Install the debris bag onto the upper handle. Locate the
bag straps at each of the four corners of the bag. Each
NOT FOR REPRODUCTION