Biltek SL600ACL - Safety Information

1
Warning!
Safety Information
• Read these instructions
CAREFULLY
before installation and use. Provide them to any
technician used to install, maintain, or repair this device and provide them with the device if it
is ever given or sold to a third party.
• Install and use this gate opener
ONLY
in accordance with these instructions and all applicable
local and national laws and regulations. Adding clearly visible warning signs is a requirement
for UL 325 compliance and may be necessary in your area. Only use the device for its
intended purpose, opening and closing a single sliding gate for Class I residential vehicular
traffic. Always aim to minimize public exposure to potential hazards such as pinch points.
Failure to do so may result in serious property damage and severe personal injury.
• Installandusethisgateopeneronlyonrmlevelground.Installandusethisdevicesothat
its motor and other hazardous components are not in public areas and are protected as much
as possible from unauthorized access and use. There should be adequate clearance between
your gate and any nearby structures to prevent any possibility of a pinching or crushing
hazard during use. If this is impossible, the area should be guarded as well as possible and
warnings clearly placed nearby.
•
ONLY
allow trained technicians to install and repair this device and its electrical connections.
Disconnect all power from electronic components during installation and maintenance except
as instructed for safely testing functionality.
• Conrm
BEFORE
any digging that there are no nearby gas, power, or other utility lines or that
all such lines have been fully disabled and cleared to allow safe work.
•
ONLY
usethisdeviceforasingleslidinggateintendedforvehiculartra󰀩c.Pedestriansshould
be provided with a separate access point far enough away to ensure they never come into
contact with the moving vehicular gate.
•
DO NOT
installthisdeviceinanyareapronetooodingorinlocationsexposedtoammable
or explosive fumes.
•
ONLY
use this device with gates of compatible weight and size and stable, compatible,
and well-grounded power sources. Do not use with ungrounded power strips, 3-to-2 prong
adapters, DC batteries, or DC solar power systems.
•
ONLY
use well-connected and maintained ANSI #41 chains with this device. Never use this
device for gates wider than 40 feet (12 m) and never allow the sprockets to carry the weight
of the gate. Keep the chain correctly positioned so all weight is distributed to the gate’s own
wheels during operation.
•
ONLY
installxedcontrolsforthegatewheretheycannotbereachedover,under,around,
or through the gate. They should also be far enough away that operators cannot contact the
moving gate during use. For full UL 325 compliance, there should be a clear line of sight
between the controls and the gate but it should be located at least 6 feet (2 m) away from any
of the gate’s moving parts.
•
NEVER
allow children to play on or around this device or its attached gate. Keep controls
away from children and out of their reach at all times and warn them of the gate’s danger.
•
NEVER
pair a remote control for this device with any other control board. Never attempt to
operate this device with two or more remotes or control devices at the same time.