Biltek SL600ACL - Chain Installation

11
Chain Installation
1. Close the gate.
2. Install the gate brackets (H) at or near each end of your gate. They should face in towards your
property and be located at the same height as the two smaller sprockets on the motor. The
nearest bracket should be at least one foot (30 cm) away from the motor.
Use the square bolts (G) for gates with square posts and the round bolts (G) for gates with
round posts.
It is recommended to position the brace for the tie rod (F) on the side of the post nearer to the
motor, but it can be used in either position if necessary.
M8 Flat Washer
M8 Flat Washer
Tie Rod
Tie Rod
Square Bolt
Round BoltGate Post
Gate Post
M6 Flat Washer
M6 Flat Washer
M8 Spring Washer
M8 Spring Washer
M6 Spring Washer
M6 Spring Washer
M8 Nut
M8 Nut
M6 Nut
M6 Nut
Replace the sensors’ covers and mount them near your gate at the positions prepared for them.
If possible, cover or otherwise protect them from direct sunlight.
6. Arrange the wiring for your motor as needed, being sure it will be protected from the moving
gate. Use conduit, silicone, or other sealant to minimize exposure to the elements and limit
access by insects.