30
Three different compression rates (HIGH, MEDIUM and LOW) are provided for
1. Press <MENU/OK> and <UP/DOWN> to select ANS. MACHINE.
2. Press <MENU/OK> and <UP/DOWN> to select TAM SETTINGS.
3. Press <MENU/OK> and <UP/DOWN> to select COMPRESSION.
4. Press <MENU/OK> and <UP/DOWN> to select your desired compression
5. Press <MENU/OK> to confirm.
Your phone lets you check your messages, or otherwise operate your answering
If the answering machine is set to ON, when there is an incoming message,
the handset will display “ SCREENING? ”
1. Press <MENU/OK> to start call screening. Any Handset can listen to who is
2. The handset will display
“
SCREENING”.
3. You can adjust the earpiece volume by pressing <UP or DOWN> or listen via
3. Press <Cancel/Mute> to return to previous screen and you cannot hear the
you to select different quality levels of recording incoming message. The lower
8.5.8 Change the Compression Rate
8.5.9 Activate Remote Access
shorter the total recording time available. ( LOW=7 minutes, MEDIUM=10
minutes, HIGH=15 minutes approx).
machine, by calling the answering machine when you are away from home and
then dialling a 4-digit remote access PIN from a tone-dialling phone.
The 4-digit remote access PIN code is used to prevent other people from
unauthorised access of your answering machine.
leaving the message and decide whether to pick up the call or not.
Note: Remote Access must be turned on if you want to be able to use this
feature, see 8.5.9.2.
8.5.7.2 Screening with a handset
machine is in the process of recording, the message already stored will be
saved.
rate.
the compression rate, the higher the recording quality level attained, but the
8.5.9.1
1. Press <MENU/OK> and <UP/DOWN> to select ANS. MACHINE.
2. Press <MENU/OK> and <UP/DOWN> to select TAM SETTINGS.
3. Press <MENU/OK> and <UP/DOWN> to select CHANGE PIN.
4. Press <MENU/OK> to show PIN?---, and enter the Old PIN. (Default
Change the 4-Digit Remote Access PIN
5. Press <MENU/OK> to show NEW PIN?---, and enter your new 4-digit PIN.
6. Press <MENU/OK> to show CONFIRM?---, and enter your new 4-digit PIN
recording. At any time if you want to pick up the call, you can press <TALK>
and the message recording will be stopped automatically. If the answering
the loudspeaker by pressing <SPEAKERPHONE>.
Remote Access PIN is 0000).
again.
To Next Page
Loading...
