31
Note: If the new PIN entered in Step 6 is not the same as the new system PIN
entered in Step 5, you must enter the new system PIN at step 5 again.
7. Press <MENU/OK> to reconfirm.
4. Press <MENU/OK> and <UP/DOWN> to select ON or OFF to turn the
5. Press <MENU/OK> to confirm.
You can ring your phone from another tone-dialling phone to switch the
answering machine on or off, and/or listen to your messages remotely.
1. Place a call from a tone-dialling phone to your phone.
2. When the answering machine answers the call and starts playing the OGM,
Note: The * must be entered while the OGM is still playing, and the 4-digit PIN
3. Enter the 4-digit Remote Access PIN (default PIN is 0000). You will not hear
should be follow without any delays.
1. Press <MENU/OK> and <UP/DOWN> to select ANS. MACHINE.
2. Press <MENU/OK> and <UP/DOWN> to select
TAM SETTINGS.
3. Press <MENU/OK> and <UP/DOWN> to select REMOTE ACC.
8.5.9.2 Activate or Deactivate the Remote Access
8.5.9.3 Access Your Answering Machine Remotely
any confirmation tones or prompts, but you will need to press 5 to start
playing any messages.
press the <*> key. The OGM will stop playing
remote access on or off respectively.
Remote operation
Using a tone-dialling phone, dial your home number
You can also use the codes on the other side of this card
While your outgoing message is playing, press
Key in your remote security code
The default code is 0000. For details of how to set a new code,
see the User Guide 8.5.9.1 on page 3 .
1
2
3
4
Note: The <*> key must be entered while the OGM is still playing, and the 4-digit
Note: If your answering machine is switched off, the phone will enter into
the remote access mode after 10 rings.
You can then enter the 4-digit remote access PIN
(Default Remote Access PIN is 0000) to activate the remote access feature.
PIN should follow without any delays. If the 4-digit Remote Access
PIN is entered incorrectly three times consecutively, the line will be released
automatically.
0
system
M3i
To Next Page
Loading...
