Binder APT.line C 150-UL

Need help?

Do you have a question about the Binder APT.line C 150-UL and is the answer not in the manual?

Summary

1. SAFETY

1.4 General safety instructions

Key precautions for installation, operation, and maintenance.

1.5 Intended use and prohibitions

2. UNIT DESCRIPTION

2.1 CO2 measuring principle

2.2 Unit overview

Visual identification and description of major components of the C 150 incubator.

3. DELIVERY, STORAGE, AND INSTALLATION

3.2 Safe lifting and transportation

3.3 Location and ambient conditions

Requirements for the installation site and environmental factors.

4. INSTALLATION AND CONNECTIONS

4.2 CO2 sensor and gas connection

Procedures for connecting the CO2 sensor and gas supply.

4.3 Electrical connection

Procedure for connecting the unit to the power supply.

6. RP1 CONTROLLER FUNCTION OVERVIEW

6.1 Preset factory parameters

7. CONTROLLER RP1 OPERATING MODES

7.1 Selecting and setting functions

7.2 Operating modes HAND and USER

Basic and advanced control modes for setting temperature and CO2.

7.3 Operating mode LOCK and power failure performance

8. CONTROLLER RP1 SETTINGS

8.1 Altitude setting

8.2 Setting temperature and CO2 set points

Instructions for configuring desired temperature and CO2 concentration.

9. TEMPERATURE SAFETY DEVICES

9.1 Over-temperature protection

9.2 Safety controller settings

Explains the secondary safety controller and how to set its parameters.

10. ALARM FUNCTIONS

10.1 Alarm overview and reset

10.3 Temperature alarms

10.4 Environmental and gas alarms

12. REFERENCE MEASUREMENTS

12.1 CO2 reference measuring

Methods to verify CO2 concentration using external tools.

14. AVOIDING MICROBIAL CONTAMINATION

14.2 Chamber design for contamination control

Features of the incubator designed to minimize contamination risks.

14.3 Handling the incubator

15. CLEANING, DECONTAMINATION, STERILIZATION

15.1 Cleaning procedures

Detailed instructions for cleaning various parts of the incubator.

15.2 Decontamination and disinfection

Methods for disinfecting the interior and components.

15.3 Hot-air sterilization

Procedure for performing the automatic hot-air sterilization cycle.

15.4 Aborting hot-air sterilization

16. MAINTENANCE AND SERVICE

16.1 Maintenance intervals and service

17. DISPOSAL

17.2 Decommissioning

17.3 Disposal regulations (Germany)

17.4 Disposal regulations (EC;Non-EC)

18. TECHNICAL DESCRIPTION

18.1 Factory calibration and technical specifications

Details on factory calibration, usable volume, and unit specifications.

18.3 Equipment, options, and dimensions