Why is my Binder unit without function?
If your Binder unit isn't working, there could be several reasons. First, check the connection to the power supply. Ensure the power supply matches the unit's voltage requirements (100-120V or 200-240V). Also, inspect the unit fuse and replace it if necessary. If the fuse blows again, it is recommended to contact BINDER service.
What to do if the Binder chamber doesn’t heat up?
If the Binder chamber isn't heating up, the safety controller might have turned it off because the limit temperature was reached, or the safety controller is set too low. Allow the unit to cool down, then press the RESET button. Check the temperature set-point and the safety controller setting. If needed, select a more suitable limit value. Note, if the safety controller is defective, contact BINDER service.
Why is the set-point temperature not reached in my Binder?
If the set-point temperature isn't reached in your Binder unit, here are a few things to check: * Make sure the unit door is completely closed. * If the door gasket is defective, replace it. * The controller may need adjustment; calibrate and adjust it.
What to do if my Binder chamber is heating permanently?
If your Binder chamber is heating constantly and exceeding the set-point, the controller might be defective, so it is recommended to contact BINDER service. It could also be that the controller needs adjustment; in this case, calibrate and adjust the controller.
What to do if overtemperature safety controller class 3.1 responds in my Binder?
If the overtemperature safety controller class 3.1 responds, it means the safety controller set-point value has been exceeded. Check the setting of the temperature set-point and the safety controller class 3.1 set-point. If appropriate, select a suitable value. Also, too much external heat load can cause this, so reduce the heat load. Note, if the controller is defective, contact BINDER service.
Why does my Binder have very long heating-up times?
If your Binder unit has very long heating-up times, it could be because the chamber is fully loaded. Try loading the unit less or consider allowing longer heating-up times.
What to do if low refrigerating performance in Binder?
If you're experiencing low or no refrigerating performance with your Binder unit, it could be due to several factors. If the ambient temperature is above 25 °C / 77°F, select a cooler place of installation. Also, too much external heat load can cause this, so reduce the heat load. If the refrigerating system is not turned on, contact BINDER service.
What to do if overtemperture safety controller responds with option safety controller class 3.3 in Binder?
If the overtemperature safety controller responds with option safety controller class 3.3, it means the safety controller set-point value has been exceeded. Check the setting of the temperature set- point and of the safety controller class 3.1 set-point. If appropriate, select a suitable value. Also, too much external heat load can cause this, so reduce the heat load. If the controller is defective, contact BINDER service.
Why does program duration longer than programmed in Binder?
If the program duration is longer than programmed in your Binder unit, it's likely due to inappropriate tolerances being programmed. For rapid transition phases, do NOT program tolerance limits to allow maximum heating speed.
Why does program stops one section too early in Binder?
If the program stops one section too early in your Binder unit, it indicates that the program line is incomplete. When programming with setting “ramp”., define the end value of the desired cycle by adding an additional section with a section time of at least one minute.
General| Brand | Binder |
|---|---|
| Model | APT.line KT 53 |
| Category | Accessories |
| Language | English |
To Next Page