To Next PageTo Next Page
Need help?Do you have a question about the Binder APT.line C 150 and is the answer not in the manual?
General| Brand | Binder |
|---|---|
| Model | APT.line C 150 |
| Category | Accessories |
| Language | English |
Explains safety definitions, symbols, warning panels, and their structure.
Location of safety labels and details of the type plate.
Crucial safety guidelines for installation and operation.
Specifies the intended purpose and approved applications of the incubator.
Explains the infrared measuring system and its accuracy.
Diagram and list of main components, connection panel, and controller panel.
Information about the outer and inner glass doors, including heating.
Steps for receiving, inspecting, and preparing the unit.
Instructions for safely moving, transporting, and storing the incubator.
Requirements for the installation site and environmental factors.
How to insert shelves and their load limits.
Information about the CO2 sensor, its handling, and connection.
How to install, fill, and maintain the water pan for humidity.
Procedures for connecting CO2 gas supply and electrical power.
Default settings for temperature, CO2, and safety controller.
What to expect during the initial equilibration phase.
How to navigate and change settings on the controller.
Basic mode for setting parameters.
Mode for advanced configuration and password protection.
How to secure settings using a password.
How the unit behaves during power interruptions.
Setting altitude for accurate CO2 measurement.
How to adjust temperature and CO2 concentration set points.
Describes the primary over-temperature protection.
Explains the secondary safety temperature controller.
How to select between 'Limit' and 'Offset' for the safety controller.
Procedure to set the actual safety controller set point value.
Lists alarms and procedures to clear them.
Connecting the unit to an external monitoring system.
Actions for safety controller over-temperature.
Handling temperature deviations from the set point.
Alarm triggered when the chamber door is left open.
Alarms for incorrect CO2 levels or low pressure.
Actions for temperature or CO2 sensor malfunctions.
Methods for verifying CO2 concentration accuracy.
How to perform reference temperature measurements.
Installation and use of optional ports for cables.
Options for mobility and stacking units.
Features of optional analog outputs for data logging.
Guidelines for handling cultures, media, and lab environment.
How the unit's design aids in preventing contamination.
General practices for handling and cleaning to prevent contamination.
Procedures and agents for cleaning the unit's surfaces.
Methods for disinfecting the incubator.
Specific instructions for cleaning the CO2 sensor.
Details the automatic hot-air sterilization cycle.
How to interrupt the sterilization cycle and its consequences.
Recommended service schedule and contact information.
User checks for fan operation and gas filter maintenance.
Procedure for returning the unit for repair or service.
How to dispose of packaging materials.
Steps for taking the unit out of service and disposal regulations.
Details on factory calibration procedures and standards.
Information on fuse protection and usable volume calculation.
Comprehensive technical data, conversions, and specifications.
Lists standard equipment, options, and available spare parts.
Technical drawings showing the unit's dimensions.
