Why is my Binder APT.line KB unit not working?
If your Binder Accessories unit isn't functioning, there could be several reasons. First, ensure it's properly connected to a power supply. Check that the voltage matches either 115V or 230V. Then, inspect the unit fuse and replace it if necessary. If the fuse blows again, contact BINDER service.
What to do if set-point temperature is not reached in Binder Accessories?
If the set-point temperature in your Binder Accessories is not reached after the specified time, make sure the unit door is completely closed. Also, inspect the door gasket and replace it if it's defective. Finally, calibrate and adjust the controller.
What to do if Binder Accessories chamber doesn’t heat up and LED (3a) “Heating active” not lit?
If the chamber of your Binder Accessories unit isn't heating up and the LED (3a) “Heating active” is not lit, allow the chamber to cool down, then press the RESET button. Check the temperature set-point and the setting of the safety controller. If needed, select a suitable limit value.
Why is Binder APT.line KB chamber heating permanently and set-point not maintained?
If the chamber in your Binder Accessories is heating permanently and the set-point is not maintained, calibrate and adjust the controller. If the problem persists, contact BINDER service.
What to do if mechanical safety device class 3.1 responds in Binder Accessories?
If the mechanical safety device class 3.1 responds in your Binder Accessories (with option safety device class 3.3), check the temperature set-point and the setting of safety device class 3.1. Select a suitable limit value if needed. Also, reduce the external heat load. If these steps don't resolve the issue, contact BINDER service.
What to do if mechanical safety device class 3.2 responds in Binder Accessories?
If the mechanical safety device class 3.2 responds in your Binder Accessories (with option safety device class 3.3), check the temperature set-point and the setting of safety device class 3.2. If appropriate, select a suitable limit value. If the issue continues, contact BINDER service.
Why are there deviations from the indicated heating-up times in Binder APT.line KB Accessories?
If you're experiencing deviations from the indicated heating-up times in your Binder Accessories, it may be due to the oven being fully loaded. Try charging the chamber with less material or consider allowing longer heating-up times.
What to do if Binder APT.line KB Accessories chamber doesn’t heat up but LED (3a) “Heating active” lit?
If the chamber of your Binder Accessories unit isn't heating up, but the LED (3a) “Heating active” is lit, contact BINDER service.
Why is refrigerating performance low in Binder APT.line KB?
If you're experiencing low refrigerating performance with your Binder Accessories, it could be due to several factors. Ensure the ambient temperature is not greater than 20 °C by selecting a cooler location for installation. Reduce the heat load. If the problem persists, contact BINDER service.
Why is the program duration longer than programmed in Binder APT.line KB Accessories?
If the program duration is longer than programmed in your Binder Accessories, it may be because inappropriate tolerances have been programmed. For rapid transition phases, do NOT program tolerance limits in order to allow maximum heating speed.
General| Brand | Binder |
|---|---|
| Model | APT.line KB Series |
| Category | Accessories |
| Language | English |
To Next Page