What to do if my Binder APT.line BD unit has no function?
If your Binder unit isn't functioning at all, start by checking the power supply connection. If that's okay, inspect the unit fuse and replace it if necessary. If the fuse blows again, contact BINDER service.
Why is the set-point temperature not reached in my Binder APT.line BD?
If the set-point temperature in your Binder Accessories unit isn't reached after the specified time, make sure the unit door is completely closed. Also, check if the door gasket is defective and replace it if needed. Ensure that the controller is calibrated and adjusted correctly, and verify that the power supply matches the voltage requirements (115V or 230V).
How to turn on Binder APT.line BD unit if only the green stand-by LED is lit?
If your Binder unit is only showing the green “stand-by” LED, it's likely in stand-by mode. Press and hold the ON/OFF button until the display illuminates.
What to do if temperature is too high and the red alarm pilot lamp is lit in Binder Accessories?
If the temperature inside the chamber of your BD, option ED, FD Binder Accessories unit is too high and the red alarm pilot lamp of safety device is lit, check the temperature set-point and the safety device class 3.1 settings.
What to do if Binder APT.line BD unit doesn't function and the red alarm pilot lamp is lit?
If your ED, FD Binder Accessories unit isn't working and the red alarm pilot lamp is lit, the safety device class 2 may have shut down the chamber. Allow the chamber to cool down, then press the RESET button. Check the temperature set-point and the safety device class 2 settings, and select a suitable limit value if necessary.
What to do if Binder APT.line BD chamber doesn’t heat up and the red light is off?
If the chamber in your Binder Accessories unit isn't heating up, and the red heating control light in the display is not lit but the controller display is working, ensure the timer is correctly programmed or set to continuous operation.
Why are there deviations from heating-up times in Binder APT.line BD?
To address deviations from the indicated heating-up times in your Binder oven, reduce the oven load or allow for longer heating-up times.
Why is my Binder APT.line BD Accessories chamber heating permanently?
If the chamber in your Binder Accessories unit is heating permanently and the set-point isn't being held, calibrate and adjust the controller.
Why does the Binder Accessories controller return to Normal Display?
If the controller returns to the Normal Display from any level, repeat entries and enter the values rapidly, because no button was hit for more than 60 sec.
What to do if fan doesn’t turn in Binder Accessories?
If the fan in your FD Binder Accessories unit isn't turning or is turning too slowly, contact BINDER service.
Meaning of warning signs, pictograms, and safety alert symbols for hazard communication.
Key instructions for safe installation and operation of BINDER incubators and ovens.
Defines approved applications for Incubators BD and Heating ovens ED/FD.
Description of the unit's components, features, display, and controls.
Procedures for unpacking, installation, electrical connection, and storage.
Steps to power on the unit and initial operation checks.
Setting temperature set-points and managing timer/continuous operations.
User level settings, unit address, and temperature ramp programming.
Function and settings for safety thermostats class 2 and 3.1.
Overview of available optional features like alarms, software, and sensors.
Guidelines for regular maintenance, cleaning, and decontamination.
Procedures for unit disposal according to environmental regulations.
Table of fault descriptions, causes, and required measures.
Detailed specifications for BD, ED, and FD models.
Lists standard equipment and available accessories for each series.
Part numbers for accessories and replacement components.
Form for declaring safety and health information for returned units.
General| Brand | Binder |
|---|---|
| Model | APT.line BD Series |
| Category | Accessories |
| Language | English |
To Next Page