To Next PageTo Next PageWhy does the controller of my Binder Oven return to Normal Display from any level?
If the controller of your Binder Oven returns to the Normal Display from any level, it may be due to no button being pressed for approximately 30 seconds. Repeat your entries and enter the values rapidly.
Information on legal aspects and user responsibilities for manual content.
Explains the organization and components of safety information.
Details on signal words used to indicate danger severity.
Explanation of the safety alert symbol and its meaning.
Visual representations of hazards and mandatory actions.
Defines the format and content of hazard warning panels.
Identifies the positions of safety labels on the chamber.
Details found on the chamber's identification plate.
Essential safety guidelines for installing and operating chambers.
Specifies the authorized applications and limitations of the chamber.
Visual guide to the chamber's components and controls.
Procedure for inspecting the chamber upon receipt.
Guidelines for safely moving and transporting the chamber.
Recommendations for storing the chamber before installation.
Requirements for the chamber's installation site and environment.
Instructions for connecting the chamber to the power supply.
Guidance on connecting an optional suction plant.
Step-by-step guide to powering on the chamber.
Explanation of indicators for heating status.
How to adjust the air circulation within the chamber.
Setting temperature and fan speed without programmed ramps.
Setting temperature and fan speed with programmed ramps.
Configuration of continuous and timer-based operation modes.
Accessing and modifying user-configurable controller parameters.
Illustrative example of setting up a temperature program.
Miscellaneous notes and tips for controller usage.
Functionality and checking of the Class 2 temperature safety device.
Details on the optional Class 3.1 temperature safety device.
Description of the optional audible alarm feature.
Information on using the chamber with APT-COM™ software.
Details about the optional data logger for temperature recording.
Information on the optional HEPA filter for air purification.
Description of the gas-tight feature for specific models.
Instructions for connecting inert gas for specific models.
Details on the analog output for temperature data transmission.
Schedule and procedures for regular maintenance and service.
Guidelines for cleaning the chamber's interior and exterior.
Steps for decontaminating the chamber after hazardous substance contact.
Process for sending the chamber back to BINDER for service.
Instructions for disposing of the chamber's packaging materials.
Procedure for safely taking the chamber out of service.
Regulations for disposing of the chamber in Germany.
Regulations for disposing of the chamber within EC countries.
Guidelines for disposal outside European Community states.
Information on the chamber's factory calibration process.
Explanation of how the chamber's usable volume is calculated.
Details on the chamber's protection against overcurrent.
Comprehensive technical data table for FED models.
Overview of standard equipment and available optional features.
List of available accessories and replacement parts.
Statement confirming compliance with EC directives.
Certificate for the GS safety mark from VDE Institute.
Form for declaring contamination status for non-NA/CA chambers.
Form for declaring contamination status for NA/CA chambers.
General
