What to do if the Binder Oven chamber is heating permanently and not maintaining the set-point?
If your Binder Oven chamber is heating permanently and not maintaining the set-point, it could be due to a controller that is not adjusted properly. Calibrate and adjust the controller to resolve this issue.
Why is my Binder M Series Oven chamber not heating up when turned on and the safety device class 2 responds?
If your Binder Oven chamber doesn’t heat up when turned on and the safety device class 2 responds, it may be because the limit temperature has been reached or the safety device class 2 is set too low. Allow the chamber to cool down and press the RESET button. If needed, choose a more suitable limit value.
What to do if the safety device class 3.1 (option) responds in my Binder M Series?
If the safety device class 3.1 responds in your Binder Oven, it might be because the limit temperature has been reached. Check the temperature set-point and the setting of safety device class 3.1. If necessary, choose a suitable limit value.
Why does my Binder M Series display flashing 1999, -1999, or 9999?
If your Binder Oven display is flashing 1999, -1999, or 9999, it could be due to an initialization problem from turning on the chamber too early. Allow approximately 30 seconds between turning the chamber off and on again.
What causes wrong temperature alarms or disturbance of temperature accuracy in a Binder M Series Oven?
Wrong temperature alarms or disturbance of temperature accuracy in your Binder Oven can be caused by the temperature unit being changed to °F. Set the temperature unit back to °C.
What should I do if the Binder Oven chart recorder function clears the measured-value memory?
If the chart recorder function clears the measured-value memory in your Binder Oven, this may be due to a new setting of the storage rate. Only change the storage rate if the previously registered data are no longer required.
What should I do if the Binder Oven controller does not attain set-points entered in Manual Mode?
If the Binder Oven controller does not attain set-points entered in Manual Mode, it is possible that the chamber is in Idle Mode because the EXIT or AUTOMATIC button was pressed. Change back to Manual Mode.
What to do if the Binder Oven controller does not attain program set-points?
If the Binder Oven controller does not attain program set-points, it might be because the chamber is in Idle Mode due to pressing the EXIT or AUTOMATIC button. Restart the program.
Why is the Binder M Series program duration longer than programmed?
If the Binder Oven program duration is longer than programmed, it is because tolerances have been programmed. For rapid transition phases, do not program tolerance limits to allow maximum heating speed.
Why does the Binder M Series Oven program stop one section too early?
If the Binder Oven program stops one section too early, the program line is incomplete. When programming, define the end value of the desired cycle by adding an additional section with a section time of at least one second.
General| Temperature Range | RT +5 °C to 300 °C |
|---|---|
| Application | Drying |
| Power Supply | 230 V 1~ / 50 Hz or 120 V 1~ / 60 Hz (depending on model) |
| Power Consumption | Varies by model, consult datasheet |
| Weight | Varies by model, consult datasheet |
| Exterior Dimensions (W x D x H) | Varies by model, consult datasheet |
| Interior Dimensions (W x D x H) | Varies by model, consult datasheet |
| Timer | 99 hours, 59 minutes |
To Next Page
