EasyManuals Logo

Bio-Logic SP-300 User Manual

Default Icon
122 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #44 background imageLoading...
Page #44 background image
Manual for VMP300-based instruments
36
Fig. 42: “Advanced Ethernet settings” of the
“New Device” window used to change the
instrument IP Address.
Modify the IP Address to have a valid address in your network. Repeat this procedure with the
Gateway and click on Modify device”. Then the new IP Address is sent to the instrument and
a “configuration changed” message appears in green. Several “Bip” sounds are emitted by the
instrument indicating that the communication board is reinitialized with the new IP Address.
“Configuration changed” appears at the bottom of this window.
Fig. 43: New configuration.
Then click OKto display the “New Device” window and “Refresh” to refresh the window and
select your instrument’s IP address. Click on the “Select” button.
Now the instrument is connected and ready for use.

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Bio-Logic SP-300 and is the answer not in the manual?

Bio-Logic SP-300 Specifications

General IconGeneral
BrandBio-Logic
ModelSP-300
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals