8
4) Checking your air compressor
To supply polisher with clean and dry air, drain air fi lter of the compressor in your dental offi ce. Do not supply compressed air
containing moisture. For drainage and regular maintenance of your compressor, please refer to your air compressor’s instruction
manual. Confi rm the compressor is maintained according to its instructions for use.
7.2 Air pressure setting (at fi rst use)
1) Preparation of polisher
(a) If polisher is connected to a turbine hose, disconnect it from the turbine hose.
(b) Attach the head and powder cap to the chamber unit according to “7.3 Attaching head” and “7.4 Attaching powder cap”.
Do
not fi ll the powder yet.
2) Connection
(a) Connect your coupling (separately sold) to your turbine hose. Confi rm secure connection.
(b) Connect a pressure gauge to your coupling on your turbine hose until you hear a locking sound. Confi rm the gauge is fi rmly
attached. (If you don’t have a pressure gauge, consult with your dental dealer.)
(c) Connect polisher to the coupling of the pressure gauge until you hear a locking sound. Confi rm the gauge is fi rmly seated.
8
4) Checking your air compressor
To supply polisher with clean and dry air, drain air fi lter of the compressor in your dental offi ce. Do not supply compressed air
containing moisture. For drainage and regular maintenance of your compressor, please refer to your air compressor’s instruction
manual. Confi rm the compressor is maintained according to its instructions for use.
7.2 Air pressure setting (at fi rst use)
1) Preparation of polisher
(a) If polisher is connected to a turbine hose, disconnect it from the turbine hose.
(b) Attach the head and powder cap to the chamber unit according to “7.3 Attaching head” and “7.4 Attaching powder cap”.
Do
not fi ll the powder yet.
2) Connection
(a) Connect your coupling (separately sold) to your turbine hose. Confi rm secure connection.
(b) Connect a pressure gauge to your coupling on your turbine hose until you hear a locking sound. Confi rm the gauge is fi rmly
attached. (If you don’t have a pressure gauge, consult with your dental dealer.)
(c) Connect polisher to the coupling of the pressure gauge until you hear a locking sound. Confi rm the gauge is fi rmly seated.
To Next Page
Loading...