BIOCLEAR Blaster BC-B5000 - Water Removal in Channels (Idle Run)

14
2) Connecting a coupling
(a) Connect a coupling (separately sold)
compatible with your polisher to your turbine
hose. Confi rm the coupling is fi rmly seated.
3) Connecting to turbine hose
(a) Insert your coupling on your turbine hose
into the joint of polisher until you hear a
locking sound. Confi rm the handpiece is
fi rmly seated.
(b) If your coupling has a light source, turn off
the illumination switch of your dental unit.
CAUTION
When connecting your coupling to this product, confi rm secure connection after hearing a locking sound. Make sure the head
and powder cap are fi rmly screwed in. A failure to attach correctly may cause injury due to instrument becoming disconnected
or powder being scattered.
ATTENTION
To avoid shortening the life of the light source (light bulb) of your coupling, turn off the illumination of your dental unit when
using this product.
Coupling Turbine hose
14
2) Connecting a coupling
(a) Connect a coupling (separately sold)
compatible with your polisher to your turbine
hose. Confi rm the coupling is fi rmly seated.
3) Connecting to turbine hose
(a) Insert your coupling on your turbine hose
into the joint of polisher until you hear a
locking sound. Confi rm the handpiece is
fi rmly seated.
(b) If your coupling has a light source, turn off
the illumination switch of your dental unit.
CAUTION
When connecting your coupling to this product, confi rm secure connection after hearing a locking sound. Make sure the head
and powder cap are fi rmly screwed in. A failure to attach correctly may cause injury due to instrument becoming disconnected
or powder being scattered.
ATTENTION
To avoid shortening the life of the light source (light bulb) of your coupling, turn off the illumination of your dental unit when
using this product.
Coupling Turbine hose
15
7.6 Water removal in channels (idle run)
1) Confi rm no powder remains within the powder chamber.
2) Direct the nozzle to your cuspidor. Depress your foot
control without water supply from the dental unit. Run
for 1 minute to remove water remaining in the channels
of polisher.
ATTENTION
Run polisher for 1 minute without powder before use. If water remains inside of the main body, powder will become damp and
cause clogging.
Stop water supply.
Idle run for 1 min.
15
7.6 Water removal in channels (idle run)
1) Confi rm no powder remains within the powder chamber.
2) Direct the nozzle to your cuspidor. Depress your foot
control without water supply from the dental unit. Run
for 1 minute to remove water remaining in the channels
of polisher.
ATTENTION
Run polisher for 1 minute without powder before use. If water remains inside of the main body, powder will become damp and
cause clogging.
Stop water supply.
Idle run for 1 min.