BIOCLEAR Blaster BC-B5000 - 7.7 Powder filling

16
7.7 Powder fi lling
1) Remove polisher from the turbine hose before refi lling
with powder.
2) Detach the powder cap by turning in the direction of the
arrow in the illustration above.
3) Confi rm the powder stirring cap is attached in place.
4) If water, oil, or powder remains inside of powder chamber
or powder cap, remove it with a dry cloth.
5) Fill sodium hydrogen carbonate powder not exceeding 15g
into the powder cap.
* The powder must be placed into the powder
cap. Take care not to spill the powder over the
thread of the powder cap. If the powder is spilt
over the thread, wipe it off with a dry cloth.
Filling too much powder will make the powder
adhere to the powder seal and cause
premature wear of the powder seal or
incomplete sealing.
6) Hold the chamber unit downward and the powder cap
upward as shown in the illustration. Turn the powder cap
in the direction of the arrow until it stops.
Remove water, oil, and powder.
Fill the powder into
the powder cap.
Confirm the powder
stirring cap is
attached in place.
16
7.7 Powder fi lling
1) Remove polisher from the turbine hose before refi lling
with powder.
2) Detach the powder cap by turning in the direction of the
arrow in the illustration above.
3) Confi rm the powder stirring cap is attached in place.
4) If water, oil, or powder remains inside of powder chamber
or powder cap, remove it with a dry cloth.
5) Fill sodium hydrogen carbonate powder not exceeding 15g
into the powder cap.
* The powder must be placed into the powder
cap. Take care not to spill the powder over the
thread of the powder cap. If the powder is spilt
over the thread, wipe it off with a dry cloth.
Filling too much powder will make the powder
adhere to the powder seal and cause
premature wear of the powder seal or
incomplete sealing.
6) Hold the chamber unit downward and the powder cap
upward as shown in the illustration. Turn the powder cap
in the direction of the arrow until it stops.
Remove water, oil, and powder.
Fill the powder into
the powder cap.
Confirm the powder
stirring cap is
attached in place.