2) Recording Setup
It is a mode to control the setup values of printing speed, grid indication, contrast, automatic
NST function, and automatic fetal movement detection.
▣ How to Operate the Recording Setup Mode
① Press the Reference key for over two seconds to change into the recording setup mode.
② Press the Reference key for a short time at the recording setup mode to move to the next
item.
③ Press the VOLUME △/▽ key to change the set-up value.
④ Press the Record key to store the set-up value and then return it to the basic state.
⑤ Press the Alarm key to cancel the set-up value and then return it the basic state.
▣ How to Set the printing Speed, Grid Indication, and Contrast
① To set the printing speed, press the Reference key for over two seconds and then for a
short time to indicate the following. It indicates that the (output is at a speed of 3
centimeters a minute now.) printing speed is 3 cm/min now.
The output speed can be set at one of 1, 2, and 3 cm/min, and may be changed with the
Volume Up/Down Key.
② Thermal paper for a facsimile can be used for FC-700 besides those supplied. To use those
for a facsimile, press the Reference key for over two seconds and then for a short time to
indicate the following.
Select 0 for sheets supplied by this company and 1 for those for a facsimile, and use the
Volume Up/Down Key to change it. If the set-up value is 1, Grid is printed at a sheet for a
facsimile with a signal.
To Next Page
Loading...