Bionet FC-700 - General Precautions on Electric Safety; Electrical Safety and Interference Guidelines

Rev.2.41 6
Fetal Monitor FC-700 Operating Manual
General Precaution on Electric Safety
Check the items listed below before operating the equipment.
- Be sure that power supply line is appropriate to use.
(Power Adaptor Input : 100 - 240V AC, 50-60Hz, 1.5A, Output : 18V, 2.8A).
- Be sure that the entire connection cable of the system is properly and firmly fixed.
Note
The equipment should not be placed in the vicinity of electric generator, X-ray,
broadcasting apparatus to eliminate the electric noise during operation. Otherwise, it may
cause incorrect result.
Self-power line is important for FC-700. To use same power source with other electric
instruments may cause incorrect result.
Warning statement for class i me equipment indicating: “warning: To avoid risk of electric
shock, this equipment must only be connected.
Warnings regarding significant risks of reciprocal interference posed by me equipment
during specific investigations or treatments.
Note
FC-700 is classified as listed below ;
- This equipment conforms to Class I, Type-BF.
- Do not use the equipment in the vicinity of flammable anesthetics and solvents.
- The equipment conforms to Class I according to IEC/EN 60601-1 (Safety of
Electric Medical Equipment)
This equipment conforms to Level B according to IEC/EN 60601-1-2 (Electromagnetic
Compatibility Requirements)
Note
Accessory equipment connected to the analog and digital interfaces must be certified
according to the respective IEC standards ( e.g. IEC 950 for data processing equipment
and IEC 601-1 for medical equipment ). Furthermore all configuration shall comply with
the system standard EN 60601-1-1:1993.
If in doubt, consult the technical service department or your local representative.
Note
Please check the below.
- The protective earth connection points connect separated adapter.
- FC700 obtain certification adapter to use, so don’t have to test this equipment.
- This equipment doesn’t have protective earth connection point.
- Authenticated adapter is the equipment that has passed through the protective
earth connection test.
- Protective earth connection test is the equipment itself is replaced by a test of the
certified adapter.
- Therefore, there is no need to test the protective earth connection point with this
equipment.