Bionics BFM-900L - 2.3 Maintenance and Cleanness; Chapter 3. Overview of BFM-900 L; 3.1 Principle and Features of BFM-900 L; 3.2 Composition

Overview of BFM-900L 13
BFM-900L
FETAL MONITOR
(
Ver 1.1
)
12 Precautions for Use
3.1 Principle and Features of BFM-900L
BFM-900L is a Fetal Monitor, which basically measures the fetus’s heart rate and the patient’s
uterus shrinkage. BFM-900L sends supersonic signal to the patient’s abdomen and then measures
the signal returned from the fetus’s heart. It then sorts out the Doppler frequency from the returned
signal and converts it into the heart beat of the fetus. The signal is then analyzed and displayed as
the fetus’s heartbeat and printed out on a printer. The patient’s contraction level of uterus can be
measured with pressure sensors, as well as printing out the data to inform the level of her labor
pain and frequency. BFM-900L is that the adjustments and values of the signals can easily be
controlled with simple key controls. BFM-900L is capable of measuring twin fetus, and supports
an optional central monitoring system on serial communication. It is also available AST(optional)
function.
3.2 Composition
Basic Accessories
- Supersonic Probe (DOP) (2EA)
- UC Probe (1EA)
- Event Mark Jack(1EA)
- Printer Paper (1EA)
- Power Cord (1EA)
- 110V AC Conversion Jack (1EA)
- User’s Manual (1 Volume)
- Supersonic Gel(1EA)
- Belt for Probe Fixation (3EA)
Options
- Central Monitoring Device Cable/Communication Program
- Cart
- AST Probe
- Internal Battery
2.3 Maintenance and Cleanness
You can maintain cleanliness on BFM-900L and its accessories (including the probe) in various
ways. Use the method provided below to avoid damage or contamination on the equipment.
If you use materials that can damage the product, (non-approved cleaning material) the warranty
will be voided.
Using warm water, clean the main body with alcohol on a soft cloth at least once a month, and do
not use lacquer, thinner, ethylene, and acidic cleansers. These materials can damage the device.
The cable and accessories must be maintained to avoid contact with dirt and wiped down with
warm water (approximately 104℉) on a cloth pad, and use alcohol to clean it once a week.
Do not dowse the connection parts of the accessories in liquid or detergent. Also, no liquid must
go in the connection part of the device or the accessories.
After cleaning the device, check the main body and the sensors very carefully.
If the device is overused and damaged, do not use it.
CHAPTER 3
Overview of BFM-900L