Project Type
Instructions
Date: February 12 2021
Customer: Thermor Ltd
Job Number: TH6151
Item Number: BD353
Designer: Alex Vranjesevic
Revision: C
Artwork is not to be amended or scaled. If any changes
are required please send through Thermor oce with
instructions, and we will amend here and resend artwork
through. PLEASE RETURN WITH SIGNATURE
Contact: Graphic’s Department
graphics@thermor-ins.com
Colour Breakdown
Reason For Project:
New Item:
New Branding:
Design Update:
N/A: X
UPC (For Reference Only)
5. Next ‘AL1OFF” will be displayed with “OFF” flashing. Press the MEM button to switch
between ON and OFF. Press the SET button to confirm.
a) If both AL1 and AL2 are set to “OFF”, “CL” will appear on the display. Press the SET
button to disregard. See section 3.10 Clear Measurements from Memory.
b) If AL1 and/or AL2 are set to “ON”, see section 3.12 to set the alarm.
NOTE: In order to change any setting you must repeat the process and confirm each
setting by pushing the SET button.
NOTE: Press the START/STOP button to turn the monitor ON or OFF.
3.3 Obtaining Accurate Measurements
Your blood pressure can vary based on numerous factors, physiological conditions, and your
surroundings. Follow these guidelines to obtain accurate and error-free measurements of your
blood pressure and pulse rate.
3.3A Tips on Taking Accurate Measurements
In morning before breakfast, 2
hours after dinner, before taking
medication.
Avoid coffee and smoking within the
hour, and no exercise 30 minutes
before measuring.
Do not speak while taking the
measurement.
Sit with legs uncrossed so as not to
restrict blood flow.
Empty bladder (if necessary).
Rest quietly for 5 minutes.
Remain calm and quiet while the
measurement is in process.
Take measurements on the non
dominant arm.
Sit with back supported and
measurement arm resting on a
table. Sit with feet flat on the floor.
Ensure that the cuff is level
with the heart while the arm is
supported on the table.
To Next Page
Loading...
