Project Type
Instructions
Date: February 12 2021
Customer: Thermor Ltd
Job Number: TH6151
Item Number: BD353
Designer: Alex Vranjesevic
Revision: C
Artwork is not to be amended or scaled. If any changes
are required please send through Thermor oce with
instructions, and we will amend here and resend artwork
through. PLEASE RETURN WITH SIGNATURE
Contact: Graphic’s Department
graphics@thermor-ins.com
Colour Breakdown
Reason For Project:
New Item:
New Branding:
Design Update:
N/A: X
UPC (For Reference Only)
4. Error Messages / Malfunctions
If an error occurs during a measurement the LCD displays the corresponding error code.
Error Possible Cause Remedy
Weak signal or a sudden
change in pressure
Ensure that the cuff is worn correctly and
measure again. Avoid movement or talking
when the cuff is being inflated.
External disturbance (eg. if
there is a cell phone near by)
Electromagnetic interferance can cause odd
behaviour in the monitor. Move away from
the source.
Appears when there is an error
during the inflation process
Make sure the cuff is wraped around
the arm properly and that the air plug is
properly connected to the unit.
Abnormal blood pressure
Rest for 5 minutes and try measurement
again.
In 7D Mode - Protocol was not
done correctly
Delete all measurements from the memory.
Start Protocol again. Take 4 measurements
a day ( 2 in the morning, 2 in the evening)
for 7 days straight.
Low battery Replace batteries.
If problems occur when using the device the following points should be checked, and if
necessary, the corresponding measures should be taken.
Malfunction Remedy
The display remains blank when the
device is switched on.
1. Check batteries for correct polarity.
2. If using the AC adapter, ensure it is correctly
inserted.
The pressure does not rise even though
the pump is running.
Check the connection of the cuff tube and
connect properly if necessary.
To Next Page
Loading...
