Project Type
Instructions
Date: February 12 2021
Customer: Thermor Ltd
Job Number: TH6151
Item Number: BD353
Designer: Alex Vranjesevic
Revision: C
Artwork is not to be amended or scaled. If any changes
are required please send through Thermor oce with
instructions, and we will amend here and resend artwork
through. PLEASE RETURN WITH SIGNATURE
Contact: Graphic’s Department
graphics@thermor-ins.com
Colour Breakdown
Reason For Project:
New Item:
New Branding:
Design Update:
N/A: X
UPC (For Reference Only)
The device frequently fails to measure
the blood pressure values, or the values
measured are too low or too high.
1. Check the positioning of the cuff and cuff
tension. The cuff should be snug but not
tight.
2. Measure the blood pressure again, ensuring
that you have remained motionless for
a sufficient amount of time to ensure an
accurate reading.
Every measurement produces varying
results although the instrument functions
normally and the values displayed are
normal.
Note that blood pressure fluctuates
continuously; therefore measurements will
show some variability.
Blood pressure values measured differ
from those measured by the doctor.
Record the daily developement of the values
and consult your doctor.
Note: Individuals visiting their doctor
frequently experience anxiety which can
result in a higher blood pressure reading
than at home.
For assistance call BIOS Medical Blood Pressure Hotline: 1-866-536-2289
5. Care and Maintenance
a) Do not expose the device to either extreme temperatures, humidity, dust
or direct sunlight.
b) The cuff contains a sensitive air-tight bubble. Handle this carefully and
avoid all types of stress through twisting or buckling.
c) Clean the device with a soft, dry cloth. Do not use gas, thinners or
similar solvents. Spots on the cuff can be removed carefully with a
damp cloth and soapsuds. The cuff with bladder must not be washed in
a dishwasher, clothes washer, or submerged in water.
To Next Page
Loading...
