5. Ready to print
5-1 Introduction to working mode
BIQU-B1 3D printer has two working modes, offline printing mode
and online printing mode.
Offline printing ： After adjusting the platform, save the slice file
generated by the slicing software in the TF card, then insert the TF card
into the TF card slot of the base, click "Print" from the main interface, and
then select the file in the TF card to print.
Online printing
：
Connected the computer with the 3D printer
through a data cable, using slicing software (such as Ultimaker Cura) to
control the printer. However, printing signal transmitted through the data
line may cause unstable factors such as signal interference. Therefore, it is
recommended that the customer use offline printing if possible.
Install Cura slicing
software and control
the printer through
Cura slicing software
on the computer
install driver software
to connecting PC and
printer
To Next Page
Loading...
