Difficult to install filament
Straighten the end of the filament with your
hand, and cut the very end of the
filament to a 45 degrees angle with plier.
The screw on the extruder is too tight, slightly
loosen it.
Filament jam in the white filament tube, heat up
to 230 degree and remove the
jam filament.
The nozzle is far away from the platform, adjust the
distance between the platform and the nozzle-head.
Insufficient cooling is possible, make sure the fan
is working.
Providing a closed environment in order to keep the
temperature stable.
Reducing the printing speed and allowing enough time
to adjust the temperature change.
The line width of the first layer is widened, that is, to
increase the extrusion amount of the bottom layer.
To Next Page
Loading...
