Need help?Do you have a question about the BIQU Hurakan and is the answer not in the manual?
General| Layer Resolution | 0.05-0.3mm |
|---|---|
| Nozzle Diameter | 0.4 mm |
| Filament Diameter | 1.75 mm |
| Bed Temperature | up to 100°C |
| Nozzle Temperature | up to 260°C |
| Printing Technology | FDM (Fused Deposition Modeling) |
| Connectivity | USB, SD Card |
| Supported Materials | PLA, ABS, PETG, TPU |
| Display | 3.5-inch touchscreen |
| Frame Material | Aluminum |
| Printing Speed | ≤180mm/s, Normal 60-80mm/s |
Instruction to remove the Z axis motor from the gantry by removing screws and lead screw cover.
Instruction to assemble the X axis module and gantry, paying attention to M4 holes.
Instruction to install the Z axis motor back to the gantry, aligning holes and tightening screws.
Instruction to tilt the machine base and place the gantry in its mounting slot, then tighten screws.
Instruction to loosen T-nut, place filament bracket, and tighten screw to fix it.
Instruction to install the screen by screwing it in and plugging the cable.
Connect various motor, sensor, and printhead cables to their respective ports on the printer.
Instruction to insert the PTFE tube into the bottom of the nozzle assembly.
Guidance on adjusting eccentric nuts for X, Y, and Z axes to fix shaking phenomena.
Instructions to check and set the correct household voltage switch for the printer.
Overview of the printer's screen interface, including control knob and reset button functions.
Procedure for tramming the print bed using Control -> Home All -> Manual Level -> Clear Mesh.
Instructions on how to make the filament tip pointy for easier insertion into the extruder.
Guide to adjusting the Z-offset in the secondary interface for correct nozzle height.
Link and instructions to download, install, and open Ultimaker Cura software.
Steps to set up the slicer by adding the BIQU B1 printer and configuring basic settings.
Instructions to drag and drop model files into Cura and slice them with stock settings.
Steps to transfer gcode to microSD, insert, and select file for printing.
Instructions to set WiFi SSID/password in system.cfg and connect via web interface.
Steps to transfer gcode to USB drive, plug it into the printer, and select the file.
Steps to calibrate the MicroProbe by adjusting nozzle-to-bed distance and saving configuration.
Procedure to initiate auto leveling via Control -> Bed Mesh & Save.
Guide to enable or disable the filament runout sensor via the Miscellaneous menu.
Description of expansion ports like RJ45, USB Interface, and ADXL345 Interface.
Instructions to create model thumbnails in Cura via Extensions -> Post Processing.
Step-by-step guide to physically mount the ADXL345 module onto the printhead.
Procedure for calibrating the X-axis resonance using the Klipper command line.
Instructions for mounting the ADXL345 module on the heated bed for Y-axis calibration.
Procedure for calibrating the Y-axis resonance using the Klipper command line.
Troubleshooting for layer shifting due to printing too fast or loose belts/pulleys.
Troubleshooting for filament oozing, likely caused by a loose nozzle.
Troubleshooting for print warping by adjusting distance, cooling, or adding brim support.
Troubleshooting for pits/hollows due to insufficient cooling or thin top layers.
Troubleshooting for cracks due to insufficient supply or filament diameter changes.
Troubleshooting for extruder noise caused by nozzle blockage or filament issues.
Troubleshooting for uneven filament extrusion due to jams, blockages, or poor quality.
Troubleshooting stringing by adjusting retraction, speed, temperature, or movement distance.
To Next Page
