Note: the ADXL345 module will vibrate in the X axis at this
time. Please observe to ensure that the vibration is not too
strong. (The test can be terminated in case of emergency).
After calibration, enter the save code: SAVE_CONFIG
Then power off the printer and remove the ADXL345
module.
7.6.3 Install on Heated Bed (Y Axis)
A printed part and two M3x5 screws should be prepared
first, and the printed part download link is as follows:
https://github.com/bigtreetech/BIQU-Hurakan
To Next Page
Loading...
