Step 3 After manual leveling, you can click "Plane test" in the previous
operation interface, the printer starts printing, and the customer can
evaluate the leveling effect of the platform based on the printing effect
for the next optimization.
The distance between the nozzle
and the platform is appropriate,
and the extruded filaments stick to
the printing platform.
If the distance between the nozzle
and the platform becomes too long, it
will cause the extruded filament
leaving printing platform. User should
twist the nut slightly and clockwise to
raise the platform a little bit.
If the distance between the nozzle
and the platform becomes too close,
it will cause damage to the nozzle
and printing platform.
User should
twist the nut slightly and clockwise to
low down the platform.
To Next Page
Loading...
