BITMAIN AntMiner L3+ - Monitoring Your Server

L3+ Server Installation Guide
-- ‐
13
-
- ‐
table:
5. Monitoring Your Server
5. Monitoring Your Server
To check the operating status of your server:
1. Click the status marked below.
2. Monitor your server according to the descriptions in the following
Option
Description
ASIC#
Number of chips detected in the chain.
Frequency
ASIC frequency setting.
GH/S(RT)
Hash rate of each hash board ( MH/s)
Temp(PCB)
Temperature of each hash board (°C).(Applied only to server with fixed frequency)
Temp(Chip)
Temperature of the chips on each hash board (°C).
ASIC status
One of the following statuses will appear:
● O --‐ indicates OK
● X --‐ indicates error
● -- ‐ --‐ indicates dead
Note :The server will stop running when the PCB temperatu re is over 85°C