L3+ Server Installation Guide
Resetting your server will reboot it and restore its default settings. The red LED will
automatically flash once every 15 seconds if the reset is operated successfully.
6. Administering Your Server
2.
For
Keep Settings
:
■
Select the check box to keep your current settings (default).
■
Clear the check box to reset the server to default settings.
3.
Click the (Browse) button and navigate to the upgrade file. Select the upgrade file, then click Flash
image. A message appears notifying you if the L3+ server firmware can be upgraded and if yes, will
then proceed to flash the image.
4.
When the upgrade is completed, the following message appears:
5.
Click one of the following options:
■
Reboot - to restart the server with the new firmware.
■
Go Back - to continue mining with the current firmware. The server will load the new firmware
next time it is restarted.
6.3
Modifying Your Password
To change your login password:
1.
In
System
, click the
Administration
tab.
2.
Set your new password, then click Save & Apply.
6.4
Restoring Initial Settings
To restore your initial settings
1.
Turn on the server and let it run for 5 minutes.
2.
On the controller front panel, press and hold the Reset button for 10 seconds.
To Next Page
Loading...
Need help?
General
