To Next PageTo Next Page
Need help?Do you have a question about the Bitzer CSH8553-110 and is the answer not in the manual?
General| Brand | Bitzer |
|---|---|
| Model | CSH8553-110 |
| Category | Air Compressor |
| Language | English |
Work must be done by qualified and authorized personnel according to regulations.
Addresses unavoidable risks, requiring reading instructions and following regulations.
Explains hazard prevention instructions, safety references, and symbols like NOTICE, CAUTION, WARNING, DANGER. Includes general safety references.
Specifies requirements for systems using A2L refrigerants, referencing EN378 and risk assessment.
Discusses risks and requirements for A2L refrigerants like R1234yf, including safety regulations and warnings.
Details steps for starting the compressor, including rotation check, oil monitoring, and setting pressures.
Lists essential checks before compressor start, including oil level and safety devices.
Highlights common compressor failures due to inadmissible operation modes and provides notes on expansion valve function.
Guides on horizontal installation, weather protection, and extreme condition measures.
Summarizes work steps for electrical connection of compressors, including voltage, cables, and protection devices.
Covers operating compressors with frequency inverters or soft starters, including programming and soft starter settings.
Describes motor types like part-winding and star-delta, and their operation with frequency inverters or soft starters.
Explains the requirement and setup of high and low pressure switches for compressor protection.
Covers BITZER's protection devices, safety standards, and potential failures or incorrect connections.
Describes the CM-SW-01 module for monitoring operating parameters and protecting compressors.
Details the standard SE-E1 protection device, its monitoring functions, and reset procedure.
Details SE-i1 for FI/soft starter and SE-E3 for high voltage, with their monitoring functions.
Explains oil temperature sensor function and OLC-D1-S for oil level monitoring.
Explains the oil heater's role in ensuring lubricity after standstill and preventing viscosity reduction.
Covers oil change, oil filter replacement, and notes on pressure relief and check valves.
Advises on standstill procedures and safe compressor dismantling, including refrigerant extraction.
