BIXOLON Srp-275III User Manual

Rev. 1.01
- 37 -
SRP-275III
• Errors that are impossible to recover
Error
Description
ERROR LED blinking pattern
Recovery
R/W error in memory
or gate array
After R/W checking, the
printer does not work
correctly.
Writing to, reading out, or
erasing the NV memory for
image scanning results
does not work correctly.
200ms
Recovers automatically
when the rear cover is
closed.
High voltage error
The power supply voltage
is extremely high.
Impossible to recover.
Low voltage error
The power supply voltage
is extremely low.
Impossible to recover.
CPU execution error
The CPU executes an
incorrect address or I/F
board is not connected.
Impossible to recover.
Print head temperature
detection circuit error.
There is an abnormality is
the print head temperature.
Impossible to recover.
NOTES
If you see this light blinking, turn off the printer for a few seconds and then turn it back on.
If the light is still blinking, call your supervisor or a service person.
10-2 The printer does not start printing
• Are any of the operation panel lights on, If no operation panel lights are on, check
the following:
- Make sure that the printer is turned on.
- Make sure that the power supply cable is correctly plugged into the printer and to the
power outlet.
• If any of the lights are on, please check the following:
- If the ERROR LED is on (but not blinking), the printer is off line. Check to see that the
covers are closed and check the paper state. See Chapter 5 for instructions on
installing or replacing the paper roll.
- If the ERROR LED is blinking, there is an error. In this case, turn off the printer for a
few seconds and then turn it back on. If the light is still blinking, call your supervisor or
service person.
- If the PAPER OUT LED is on, check the paper roll in the printer. See Chapter 5 for
instruction on installing the paper roll.

BIXOLON Srp-275III Specifications

General

Ethernet LAN	No
USB port	Yes
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
Connectivity technology	Wired
Parallel ports quantity	1
Storage temperature (T-T)	-20 - 60 °C
Operating temperature (T-T)	0 - 40 °C
Storage relative humidity (H-H)	10 - 90 %
Operating relative humidity (H-H)	10 - 80 %
Product color	Gray
Type	POS printer
Print speed	5.1 lps
Print technology	Dot matrix
Maximum resolution	80 x 144 DPI
Flash memory	16 MB
Internal memory	64 MB
Built-in sensors details	Paper End, Paper Near End, Wall Mounting Paper Near End, Rear Cover Open, Black Mark
Media thickness	0.06 - 0.085 mm
Maximum roll diameter	83 mm
Supported paper width	76.5 mm
Maximum printing width	63.5 mm
Power source type	AC
Mobile operating systems supported	Android, iOS
Harmonized System (HS) code	84433210

Weight and Dimensions

Depth	239 mm
Width	160 mm
Height	157 mm