Bizerba SC II 800 User Manual

Operation Operating instructions SC II
40 / 107 61429850113 en-US
6 Operation
6.1 Switching device on
The mains switch <On-Off>
is located:
– on the left side of SC II 100 scales
– on the right side of SC II 800 scales.
The scale should not be loaded.
Press <On-Off> power key.
After switch-on, the device runs through a start procedure.
The device is ready for operation when the initial display appears.
After that the weight display ranges automatically at zero "0.000" kg provided that the scale
is unloaded.
1
Initial scale display
Illustration33: Initial display
Keyboard check
When switching on the device, a keyboard check is automatically carried out. If an error is
detected, the following message appears.
The mechanical coordinate of the defec-
tive key is displayed.
X axis = 3
1
and Y axis =1
2
.
Localizing of key by means of the coordi-
nates
3
.
Contact service department.
Illustration34: Keyboard error

Bizerba SC II 800 Specifications

General

Brand	Bizerba
Model	SC II 800
Category	Scales
Language	English