What to do if the weight value display is not on zero or not stable on my Bizerba EC II 100 Scales?
If the weight value display on your Bizerba Scales is not zero or stable, there might be a few reasons. First, check if the load plate is properly attached and clear of any foreign objects or dirt. Clean the load plate if necessary. Also, ensure the scale is level. After checking these, switch the scale off and then back on.
Why does the display not light up on my Bizerba EC II 100 Scales?
If the display of your Bizerba Scales does not light up, the issue might be related to the power supply. Check the direct plug-in transformer unit and ensure it is properly connected. Also, inspect the connector for the direct plug-in transformer unit or connecting cable. If the scales use rechargeable batteries, check their status and charge them if necessary. As a last step, try switching the scale off and then back on.
Details danger levels, signal words, icons and consequences of warnings.
Specifies environmental, installation, and personnel requirements for operation.
Details mains power supply installation and interference suppression measures.
Outlines warranty conditions, liability, and training requirements.
Defines the qualifications and responsibilities of operating personnel.
Details risks associated with mains connection, voltage, and opening the device.
Details the use and requirements for rechargeable batteries.
Describes how to operate the scale using batteries and related warnings.
Covers initial installation, commissioning, and instruction procedures.
Instructions for powering up the scale and its automatic test sequence.
Describes the procedure for safely switching the scale off.
Guide to entering unit prices using the 10-key keypad.
How to call up product data (PLU) using direct PLU keys.
How to input PLU numbers using the 10-key keypad.
Procedure for taring an empty container when its weight is unknown.
How to input known tare values, including preset tare and PLU tare.
Instructions for setting unit prices for products (PLU).
Instructions for setting tare values for products (PLU).
Menu for initializing the scale and setting it to standard configurations.
Lists common faults, their causes, and recommended rectification steps.
Explains error codes (Cod) displayed by the scale and their meanings.
To Next Page
General
