Operating instruction EC II Installation
4 − 1
6.107.98.5.01.44
4 Installation
4.1 Transport and storage
Always transport and store the scale in the original packaging.
4.2 Installation and assembly
Installation, first commissioning, adjustment, initial instruction, Maintenance and repair
may only be performed by our customer service and/or by companies or persons
authorized by us.
4.2.1 Conditions for the place of installation
The place of installation must fulfil the following conditions.
− A flat installation surface.
− Vibration, oscillation and draft−free installation of our device in as dry a location as possible
must be guaranteed.
− The devices must be arranged so as to permit optimum operation, work sequences and
mainteance.
Scale in mobile mode
Since scales used on markets are subjected to various environmental conditions, such as
wind, vibrations etc., the following should be noted.
The following points must be noted in particular.
− Convey the scale to the place of use in a vertical position, resting on its foot screws.
Secure it against tilting and slipping.
− Place the scale on a level and stable surface.
− Align the scale in the horizontal position by means of the foot screws with the aid of the
spirit level, see Page 4 − 2.
− Operate the scale with mains connection or with batteries.
When operating with batteries, ensure that the batteries are fully charged.
− Wind or vibrations may cause the display to become unstable.
Set the sensitivity of the scale in the menu Pr533 , see Page 7 − 9.
− Protect the scale from humidity, rain and direct sunlight.
4.2.2 Assemble device
Unpacking
Open the packing. Remove all accessories and carefully lift the unit out of the packing.
4
To Next Page
Loading...
Need help?
General
