Bizerba EC II 100 User Manual

1
2
4
3
Operating instruction EC II Installation
4 − 9
6.107.98.5.01.44
Changing batteries
_______________________________________________________________________
CAUTION Battery fitting position !
− When inserting the batteries, you must ensure that they are fitted in
the correct position.
The symbols
+ and − are visible on the base of the battery
compartment and on the batteries.
The position of these symbols must agree!
_______________________________________________________________________
To change the batteries, a cover is located on the bottom of the scale, which is fastened with
a screw.
Fig.: Direct plug−in transformer unit
Preparation
Disconnect the scales from the mains and
disconnect the direct plug−in transformer
unit
1
.
Fig.:Scale
Remove the load plate
2
.
Fig.: Bottom of scale
Turn the scale over.
The battery compartment is accessible from
the bottom of the scale (cover)
3
.
Unscrew the screw
4
from the cover
fastening and remove the cover
3
.
4

Bizerba EC II 100 Specifications

General

Brand	Bizerba
Model	EC II 100
Category	Scales
Language	English