Operating instruction EC II About the device
2 − 7
6.107.98.5.01.44
2.9 Warranty
Installation, comissioning and initial instruction must always be performed by suitably trained
personnel from our sales offices and after−sales service centres or by companies
commissioned by us for the purpose.
We are unable to accept any liability for damage caused as a result of:
− non−observance of Bizerba operating conditions and programming instructions.
− faulty electrical connection provided by the user.
− modification of equipment in any way from its original form.
− removal of verification and protective marks.
− improper programming and operation.
− natural wear and tear.
work carried out by anyone other than representatives authorized by us and the failure to use
genuine Bizerba replacement parts or ancillary means.
When changing settings or reprogramming the equipment, always carry out a test run. This
avoids unnecessary errors.
Ensure that only trained personnel operate the equipment.
Take care to train operating personnel and ensure that they fully understand the operating
instructions. Repeat training.
These instructions are subject to revision as further product development, experience and
investigation may show is necessary or desirable. Graphics appearing in these instructions
may differ slightly from the model supplied due to country−specific regulations.
2
To Next Page
Loading...
Need help?
General
