Fuse Replacement
The meter can self-detect if its input protective fuse is either open or
damaged. In this case, the LCD will display the symbol "FUSE" and an
audible beep will sounds continuously, warning the user to replace the
damaged fuse to maintain the accuracy of measurement. While
replacing the fuse, the power of the meter must be completely shut off.
1.
Loosen screws with suitable screwdriver and remove battery cover
as
Figure-9
.
2.
Loosen screws with suitable screwdriver and remove bottom cover
as
Figure-10
.
3.
Replace the damaged fuse with specified one.
Figure-10. Fuse Replacement
To Next Page
Loading...
Need help?
General
