62
In the utility menu, when the primary display shows
“PuP”, there are two settings selectable and shown on
the secondary display. “PrE” and “SEt”.
Default Setting: PrE
Storable Settings
Primary function mode (i.e. L/C/R)
Test frequency
Secondary function mode (i.e. D/Q)
Tolerance mode state
Reference value for Tolerance mode
Relative mode state
Reference value for Relative mode
Configure and Save Power-up State
Follow the below procedure to setup and store a
power-up state into internal memory.
1. Before entering into the utility menu, configure
all the settings and parameters desired for
power up state. Do this by turning on any
modes and setting values as desired. (Only
the settings listed above in “Storage Settings”
are stored). If the meter is currently in the
utility menu, exit first and setup the desired
To Next Page
Loading...
Need help?
General
