BK Precision 9115 Programming Manual

Bit
Position
7
6
5
4
3
2
1
0
Bit Name
Not
used
Not
used
CV
CC
WTG
Not
used
Not
used
CAL
Bit
Weight
32
16
4
1
STATus:OPERation:CONDition?
This command can read the parameter from the operation condition register. When the
parameter of operation condition register changes, the bit corresponding in operation event
register is 1.
Query syntax: STATus: OPERation: CONDition?
Parameter: None
Returned parameter: <NR1>
STATus:OPERation:ENABle
This command can set the parameter of operation event enable register. Setting parameter can
determine which bit value of operation event register is 1 and the bit will change OPER of status
byte register to be 1.
Command syntax: STATus: OPERation:ENABle <NR1>
Parameter: 0~255
Example: STATus: OPERation:ENABle 128
Query syntax: STATus: OPERation:ENABle?
Returned parameter: <NR1>
STATus:OPERation:NTRansition
This command is used to edit the negative transition trigger register of operation event. The
parameter determines which bits in operation event register is 1 and will change the OPER bit
of status byte register to be set to 1.
Command syntax: STATus:OPERation:NTRansition <NR1>
Parameter: 0~255
Example: STATus:OPERation:NTRansition 128
Query syntax: STATus:OPERation:NTRansition?
STATus:OPERation:PTRansition
This command edits the positive transition trigger register of operation event. The parameter
determines which bits of operation event register is 1 and will change the OPER bit of status
byte register to be set to 1.
Command syntax: STATus:OPERation:PTRansition <NR1>
Parameter: 0~255
Example: STATus:OPERation:PTRansition 128
Query syntax: STATus:OPERation:PTRansition?

BK Precision 9115 Specifications

General

Brand	BK Precision
Model	9115
Category	Power Supply
Language	English