Need help?Do you have a question about the BK Precision 9115 and is the answer not in the manual?
General| Brand | BK Precision |
|---|---|
| Model | 9115 |
| Category | Power Supply |
| Language | English |
Defines safety category ratings based on IEC 61010 standard for electrical environments.
Covers AC input power requirements, voltage selection, and essential grounding procedures.
Details safe operating environments, temperature, humidity, and avoiding damage.
Outlines safe cleaning methods, warnings against use in critical applications, and live circuit safety.
Covers safe fuse replacement, servicing, cooling fan maintenance, and correct wire usage.
Provides additional instructions for maintaining safe instrument operation and handling.
Explains compliance with EU Directive 2002/96/EC regarding waste electrical and electronic equipment.
Lists standards met for Low Voltage Directive and Electromagnetic Compatibility Directive.
Explains various safety symbols used in the manual and on the instrument.
Describes the power supply's capabilities, user-friendly interface, and key features.
Lists all items included with the power supply shipment.
Details the physical dimensions and 1U rackmount design for installation.
Identifies and explains the function of each control and indicator on the front panel.
Identifies and explains the function of each connector and interface on the rear panel.
Explains the VFD display elements, status indicators, and modes.
Covers AC input voltage, frequency, compatibility, and the necessary AC input fuse.
Provides steps for fuse replacement and safe connection of loads to output terminals.
Steps to verify AC input voltage and perform the initial power-on self-test.
Identifies potential self-test errors and guides on checking voltage output.
Steps for checking current output and verifying the instrument's model and firmware version.
Describes the structure of the menu system and how to access it.
Guides users on configuring output voltage and current levels using front panel controls.
Explains how to set up and use remote sense for accurate voltage output compensation.
Details how to configure Over Voltage Protection (OVP) and Maximum Power Limit.
Covers factory defaults, power-on state, trigger settings, and instrument settings management.
Explains load setup, external analog control, limits, and parallel/series connection modes.
Describes the list mode feature for creating, storing, and recalling programmed sequences.
Details setting voltage, current, width, and slope for individual sequence steps.
Explains how to assemble sequences into programs and set repeat counts.
Guides on recalling stored programs from memory and initiating their execution.
Details specific automotive test capabilities like DIN 40839 and ISO 16750-2 standards.
Explains how to control output voltage transition times for rising and falling edges.
Describes how to enable and disable the front panel key lock feature.
Details physical connections for RS-232, GPIB, RS-485, and USBTMC interfaces.
Explains how to control the instrument remotely using SCPI commands.
Addresses common problems like not powering up or incorrect mode crossover.
Helps diagnose problems with USB/RS232 communication and settings.
Lists detailed technical specifications including output ratings, regulation, and accuracy.
Advises on the recommended frequency for recalibrating the instrument.
Outlines the process for returning the unit for warranty or non-warranty repairs.
Details the terms, coverage, and exclusions of the one-year limited warranty.
To Next Page
