23
EN
Problem Possible Cause Solution
LED on the
receiver flashes
rapidly and the
quadcopter will
not respond to the
transmitter (after
binding)
Less than a 5-second
wait between rst
powering on the
transmitter and
connecting the
ight battery to the
quadcopter
Leave the transmitter powered
on. Disconnect and reconnect
the ight battery to the
quadcopter
The quadcopter is
bound to a different
model memory
(ModelMatch
™
transmitters only)
Select the correct model
memory on the transmitter.
Disconnect and reconnect the
ight battery to the quadcopter
Flight battery or
transmitter battery
charge is too low
Replace or recharge batteries
Aircraft or transmitter is
too close to large metal
object, wireless source
or another transmitter
Move aircraft and transmitter
to another location and attempt
connecting again
To Next Page
Loading...
