8
HOW TO INSTALL YOUR OVEN
The electrical connections are made be-
fore the oven is installed in its housing.
• Before connecting your oven, make
sure you are using the correct size cable.
The cross-section should be the same as
the cable connected to the oven. The
fuse for your installation must conform to
the table shown opposite.
• When the oven is connected using a
separate plug and socket this must be
accessible after the oven has been instal-
led.
• When the appliance is not connected
to the mains electricity supply by a plug,
an omnipolar cutout
device (with a contacts gap of at least 3
mm) must be fitted on the supply side of
the connection to meet
requirements.
• The oven must be connected using a
standard power cable for which the num-
ber of conductors is
dependent upon the type of connection
required and in conformity with the table
shown below.
min.
network voltage connection diameter fuse
of cable
➀
230V- 50Hz 1 L + N 4 mm² 32 A
➁
400V 2N-50Hz 2 L + N 1,5 mm² 16 A
230V 2-2N-50Hz 2 L + N 2,5 mm² 16 A
3
To Next Page
Loading...
Need help?
General
