6
Installation Instructions
Electrical Connection and Safety
WARNING: The electrical connection of this appliance should be carried out by an authorised
service person or qualified electrician, according to the instructions in this guide and in compliance
with the current local regulations.
WARNING: THE APPLIANCE MUST BE EARTHED.
Before connecting the appliance to the power supply, the voltage rating of the appliance (stamped on
the appliance identification plate) must be checked for correspondence to the available mains supply
voltage, and the mains electric wiring should be capable of handling the appliance’s power rating (also
indicated on the identification plate).
During installation, please ensure that isolated cables are used. An incorrect connection could damage
your appliance. If the mains cable is damaged and needs to be replaced this should be done by a
qualified personnel.
The appliance is designed for a power supply of 220-240V, 50 Hz. If your supply is different, contact the
authorised service person or a qualified electrician.
Do not use adaptors, multiple sockets and/or extension leads, as these may overheat and catch fire.
The supply cord should be kept away from hot parts of the appliance and must not be bent or
compressed. Otherwise the cord may be damaged, causing a short circuit.
If the appliance is not connected to the mains with a plug, an all-pole disconnector (with at least 3 mm
contact spacing) must be used in order to meet the safety regulations.
After having installed the appliance, the switched outlet must always be in an accessible position.
Means for disconnection with a suitable - isolating switch must be incorporated in the fixed wiring in
accordance with the wiring rules.
The power cable (Type H05VV-F, Size 1.5 mm
2
) must be long enough to be connected to the appliance,
even if the appliance stands on the front of its cabinet.
Ensure all connections are adequately tightened.
Fix the supply cable in the cable clamp and then close the cover.
The terminal box connection is placed on the terminal box.
To Next Page
Loading...
