Blaupunkt 640 SERIES - Basic Settings; General; Video; Sound

21
Note:
With the [ Reset ] button, you can reset the custom-
ised setting again.
- Or -
쏅 Press the  Flat  button for a linear sound playback.
쏅 Press the  Loudness  button to switch increasing
the bass at low volume on or o.
쏅 Next, press 
.
The setting is stored, the current source is displayed
again.
Note:
In addition, you have the option to adjust the equal-
izer by using only three frequency bands. In the
equalizer menu, press the   button and make
the setting as described before.
Basic settings
In the settings menu, you can adjust the basic settings
for the dierent functions of the device to your require-
ments.
쏅 In the main menu, press the [ Settings ] button.
The settings menu is displayed, the General sub-
menu is activated.
쏅 Call up the submenus with the buttons in the lower
area of the settings menu.
General
The following settings are possible:
Radio region – Select the reception region for the radio
reception.
FM HICUT – Switches the Hicut lter for improving play-
back on/o.
Blackout – If this value is set, the display of the radio is
completely switched o after 10 or 20 sec. without use.
Dimmer mode – Adjust the display brightness
OFF timer – Setting the switch-o time. To protect the
vehicle battery, the device is automatically switched o
after the set time period if the vehicle ignition is switched
o.
Beep – Switch conrmation beep on/o
TFT calibration – The touchscreen can be calibrated
here.
SWC – The buttons of a connected steering wheel con-
trol can be congured here.
Rear AV-IN mode – If you connect a back-up camera
with audio signal to the AV-input at the rear of the de-
vice, you can play the camera tone via the loudspeakers
of the car sound system. To do so, enable "Camera mode".
Pandora – Pandora® can be switched on or o here
(Pandora® is available only in the US, Australia and New
Zealand).
Software version – Display of the current software ver-
sion.
Load factory settings – Resets all personalised settings.
Video
The following settings are possible:
Set password – Dene a password if you want to use the
parental controls.
Rating level – The rating of DVDs can be dened here.
If set to "Adult", all movies can be played back. If a pass-
word was congured, the rating level can be changed
only with the password
Sound
The following settings are possible:
Subwoofer – Switch subwoofer on/o
Subwoofer lter – Make the setting according to the
subwoofer used (settings: 80/120/160 Hz).
Dynamic sound – Switch dynamic bass on/o
Time
The following settings are possible:
Date – Set the date
Clock mode – Selection between 12 and 24-h mode
Time – Set the time
Auto clock – Switch automatic clock setting on or o
with the time data transmitted via RDS.
Language
The following settings are possible:
OSD – Language for the user interface of the device.
DVD audio – The audio playback of DVDs is started in the
language dened here.
DVD subtitle – The subtitles of DVDs are shown in the
language dened here.
DVD menu – The DVD menu is displayed in the language
dened here.
Sound settings | Basic settings