6
Scope of delivery
The scope of delivery includes:
t Car sound system
t Remote control (incl. battery)
t TMC tuner (only for devices with Europe navigation)
t microSD card with navigation data in the microSD
card slot (only for devices with navigation)
t GPS antenna
t External Bluetooth microphone
t Getting started
t Support frame
t Small parts set
t Installation material
t Connecting cable
Placing the device in operation
Caution!
Transport securing screws
Ensure that the transport securing screws at the top side
of the device are removed before the startup of the de-
vice.
Switching on/o
Switching on/o with the rotary/pushbutton
쏅 For switch-on, press the rotary/pushbutton
3
.
쏅 For switch-o, hold the rotary/pushbutton
3
pressed for more than 2 seconds.
Switching on/o via vehicle ignition
If the car sound system is connected with the vehicle
ignition and it was switched o with the rotary/pushbut-
ton
3
, it is switched on or o with the ignition.
Volume
Adjusting the volume
You can adjust the volume in steps from 0 (o) to 50
(maximum).
쏅 Turn the rotary/pushbutton
3
to change the vol-
ume.
Muting the car sound system (Mute)
쏅 Briey press the rotary/pushbutton
3
to mute the
device or to reactivate the previous volume.
Main menu
In the main menu, you press the buttons on the touch-
screen to call up the dierent sources and operating
modes.
쏅 Press the MENU button
2
.
- Or -
쏅 In the current source, press the
button.
The main menu is displayed.
As long as you do not select a new audio source, the
last active audio source is played back.
Note:
The gures used in these instructions are intended
to facilitate the explanations and details may deviate
from your device.
Setting the reception area
This car sound system is designed for operation in dier-
ent regions with dierent frequency ranges and station
technologies. The factory default of the reception area is
"Europe (FM/AM)". If you operate the car sound system
outside of Europe, e.g. in the US or Asia, you may rst
have to set a suitable reception area in the menu:
쏅 In the main menu, press the Settings button.
The Settings menu is displayed.
쏅 In the bottom area of the Settings menu, press the
General button.
The current setting is displayed behind "Radio region".
쏅 Tap twice (double-click) on the Radio region but-
ton to display the list of available reception areas.
쏅 Select the desired reception area by double-clicking.
The list is hidden, the selected reception area is set.
쏅 Press the
button.
The main menu is displayed again.
Scope of delivery | Startup
To Next Page
Loading...
Need help?
General
