Blaupunkt COUCH CRC 41 - BALANCE AND FADER; Adjusting Sound Balance; Adjusting Fader; Resetting Audio Settings

33
DEUTSCH
ENGLISCH
FRANÇAIS
ESPAÑOL
PORTUGUÊS
ITALIANO
NEDERLANDS
SVENSKA
NORGE
SUOMI
TÜRKÇE
Setting the Balance and
Fader
Adjusting the balance
➮ To adjust the balance, press
GEO ;.
“BAL” and the set value appear on the
display B.
➮ Turn the volume control 3 to
adjust the balance. Turn clockwise
or anti-clockwise to shift the
volume to right or left.
Balance “0” = middle setting
Adjusting the fader
➮ To adjust the fader settings for
front/rear, press GEO ;.
“BAL” and the set value appear on the
display B.
➮ Press GEO ; again.
“FADER” and the set value appear on
the display B.
➮ Turn the volume control 3 to
adjust the fader. Turn clockwise or
anti-clockwise to shift the volume to
front or rear.
Fader “0” = middle setting
Note:
The fader for front/rear cannot be set
unless an additional amplifier has been
connected.
Resetting the tone and the
balance and fader
You can reset the tone and balance/
fader settings to zero.
➮ To reset these settings press GEO
; for longer than two seconds.
“AUD ZERO” will appear briefly in the
display B.
BALANCE AND FADER