30
Adjusting equalizer treble
(E-TREBLE)
You can select 1 of 4 treble frequencies
(10 kHz, 12.5 kHz, 15 kHz, 17.5 kHz).
Note:
For further information on setting the
treble level, please read the section en-
titled "Adjusting the treble (TREBLE)"
in this chapter.
Adjusting the treble frequency
Press the AUD button =.
"BASS" appears on the display.
Press the
or button 4 repeat-
edly until "ENHANCED MENU" appears
on the display.
press the
button 4.
"E-BASS" appears on the display.
Press the
or button 4 repeat-
edly until "E-TREBLE" appears on the
display.
Press the
button 4 to open the
E-Treble menu.
"FREQ" appears on the display.
Press the
button 4 to open the
menu.
Set the treble frequency with the
or
button 4.
When you have fi nished making your chang-
es,
press the ESCAPE button ;.
쏅
쏅
쏅
쏅
쏅
쏅
쏅
쏅
Preamplifi er output
(Preamp-Out/Sub-Out)
You can use the preamplifi er outputs
(Preamp-Out) of the car sound system to
connect external amplifi ers. In addition,
you can connect an amplifi er for operating
a subwoofer to the integrated dynamic low-
pass fi lter of the device (level and cut-off
frequency can be adjusted).
For this purpose, the amplifi ers must be
connected as described in the installation
instructions.
Adjusting Sub-Out level and Sub-
Out cut-off frequency
The sub-out level can be adjusted in 8 incre-
ments (0 to +7). You can also select 1 of 3
cut-off frequencies: 80 Hz, 120 Hz, Hz and
160 Hz.
Press the AUD button =.
"BASS" appears on the display.
Press the
or button 4 repeat-
edly until "ENHANCED MENU" appears
on the display.
press the
button 4.
"E-BASS" appears on the display.
Press the
or button 4 repeat-
edly until "SUBOUT" appears on the
display.
Press the
button 4 to open the Sub-
Out menu.
"GAIN" appears on the display.
쏅
쏅
쏅
쏅
쏅
Sound Preamplifi er output
01_NewOrleansMP58us_gb.indd 3001_NewOrleansMP58us_gb.indd 30 12/28/07 2:03:30 PM12/28/07 2:03:30 PM
To Next Page
Loading...
