109
INTRODUCTION NAVIGATION RADIO MODE CD MODE INDEXSETUPCD CHANGER
ENGLISH
DEUTSCH
DEUTSCH
DEUTSCH
✔ The master code input menu opens.
Enter the four-digit master code that is printed on the equipment pass as fol-
lows:
4 use the
/ buttons on the rocker switch 7 to highlight the first digit of
the master code and
5 press the OK button 8.
✔ The input cursor jumps one position to the right.
6 Enter the remaining digits of the master code in the same way.
If you entered a wrong digit by mistake,
7 press the ESC button < or
7 highlight the
symbol and press the OK button 8.
Once you have finished entering the whole master code,
8 keep the OK button 8 pressed for longer than two seconds or
8 highlight the
symbol and press the OK button 8.
✔ You will know that the new KeyCard has been accepted when the Travel-
Pilot starts playing the audio source that was active last.
Factory default settings
The following table contains the factory default settings for the TravelPilot.
Setting Default setting
Display
Day / night On
Viewing angle 6
Brightness day 7
Brightness night 5
Special effects 0
CODE
0
0123456789
To Next Page
Loading...
