INTRODUCTION NAVIGATION RADIO MODE CD MODE INDEXSETUPCD CHANGER
98
The power-on volume is a limiting value. This means that if the volume when
you switch the unit on is lower than the configured power-on volume, the volume
level that was last set will be applied. If the volume when you switch the unit on
is higher than the configured power-on volume, the volume will be reduced to
the power-on volume level when you turn the unit on.
Note: If the power-on volume is set to maximum, the volume level
can be very high when the unit is switched on. This can cause hea-
ring damage.
To configure the volume setup,
1 open the setup menu,
2 open the VOLUME menu item,
3 use the
/ buttons on the rocker switch 7 to select the menu item
that you want to configure and
4 use the or button on the rocker switch 7 to adjust the settings.
✔ The selected menu item will appear enclosed in a dashed line border. To
help you configure the volume settings more easily, the volume will be
increased / decreased as you make your changes.
5 Press the OK button 8.
Programming the macro button
The macro button 4 is the uppermost softkey on the left of the display. You can
use the macro button to further customise the TravelPilot to your needs. You
can select a function for the macro button from a list of nine possible functions:
• TA-FUNCTION
• ROUTE GUIDANCE
• ROUTE OPTION
• LAST 10
• DEST. MEMORY
VOLUME
PHONE
NAVI-MIN
GALA
TA-MIN
-+
-+
-+
POWER-ON
-
-
+
+
SETTINGS
VOLUME
DISPLAY
MACRO BUTTON
CLOCK
LANGUAGE
To Next Page
Loading...
